Acrylic Letter Mounting Options

Standard Mountings

Plain letters are shipped without any mounting hardware.	Studs are metal threaded posts on the rear of the letters. Specify if studs need to be in line for brick or block wall mortar joints. When installed, studs typically extend approx. 1-1/2″-2″ from the back of the letters. (Brick: 2-5/8″ on center; Block: 8″ on center)	Letters/logos 3/8″ and thicker can be drilled and tapped to receive studs. Studs are metal threaded posts on the rear of the letters. Specify if studs need to be in line for brick or block wall mortar joints. When installed, studs typically extend approx. 1-1/2″-2″ from the back of the letters. (Brick: 2-5/8″ on center; Block: 8″ on center)


Pads are plastic disks on the rear of the letters. Adjustable or flush pads available upon request.	Combination has pads at the bottom and studs through pads at the top of the letter. Specify if studs need to be in line for brick or block wall mortar joints. Not for letters under 6″.	Combination All has studs through pads on all mounts. Specify if studs need to be in line for brick or block wall mortar joints. Not for letters under 6″.


Strips of 3M-VHB tape are placed strategically on the back of the letter. Follow 3M recommendations for use. Not suitable for all mounting surfaces.	This new smaller stud block is only 1/4″ OD and threaded to receive a 6-32 (1/8″ diameter) stud. Great option for thin gauge, thin stroke letters that need to be mounted flush to the surface.